搬運車是搬運貨物的一種常見物流搬運設備，常見的有手動液壓搬運車、半電動搬運車、全電動搬運車、防爆搬運車等等，它不僅提高勞動工效，還實現了安全搬移。選購搬運車時需要了解的一些常見的技術參數如下：
The carrier is a common material handling equipment for transporting goods. There are manual hydraulic truck, semi electric carrying car, all electric carrying car, explosion-proof truck and so on. It not only improves labor efficiency, but also realizes safe moving. Some common technical parameters that need to be learned when choosing a truck are as follows:
1、搬運車外形尺寸
1. The shape size of the truck
搬運車外形尺寸是指車的總長、總寬和總高，為了使搬運車具有良好的機動性能，其外形尺寸應盡量減小。
The shape dimension of the moving vehicle is the total length, width and height of the vehicle. In order to make the moving vehicle have good maneuverability, the shape dimension should be reduced as far as possible.
2、空車重量
2. The weight of the empty car
空車重量又稱自重，是指完全裝備好的搬運車質量，以kg計。搬運車自重表示搬運車質量的技術指標。
Empty truck weight, also known as self-weight, refers to the quality of fully equipped haulers, measured in kg. The weight of the hauler represents the technical index of the quality of the hauler.
3、載重量（額定起重量）
3. Load (rated weight)
載重量是指搬運車裝運時額定載物重量，即貨物中心至貨叉垂直段前臂的距離不大于載荷中心距時，允許起升貨物的重量，以t表示。
Carrying weight is the rated load weight of the carrier, that is, when the distance between the cargo center and the forearm in the vertical section is not greater than the distance from the load center, the weight of the lifting goods is allowed to be expressed in t.
4、總重量
4. Total weight
總重量是指空車重量與載重量之和。
The total weight is the sum of the weight of the empty car and the load.
5、載荷中心距
5. The center distance of the load
載荷中心距時指在貨叉上放置標準的貨物時，其貨物重心線至貨叉垂直段前臂的水平距離。
Load center distance refers to the horizontal distance from the center of gravity of the goods to the forearm of the vertical section of the fork when standard goods are placed on the fork.
6、起升高度
6. Lift height
在平坦堅實的地面上，搬運車滿載，門架垂直，貨物至比較高處，貨叉水平段的上表面至地面的垂直距離成為搬運車的起升高度。
On the flat and solid ground, the truck is loaded with full load, the door frame is vertical, the goods reach the highest place, the vertical distance from the upper surface of the fork level section to the ground becomes the lifting height of the truck.
7、爬坡度
7. Climbing slope
搬運車的爬坡度是指搬運車空載和滿載時，在正常的路面情況下，以低速擋等速運行時所能爬越的坡度，通常以度或百分?jǐn)?shù)表示。
The climbing gradient of a van is a gradient that can be climbed at the same speed as a low speed gear in normal road conditions, usually expressed as a degree or a percentage in normal conditions.